iPhone 11 Rear Camera Replacement

Is your iPhone 11 rear camera showing a completely black screen, failing to focus, shaking uncontrollably, or producing blurry photos? Replacing the dual rear camera module is a highly effective way to restore your phone's photography capabilities. This guide will walk you through the process of opening the device, safely disconnecting the battery, and swapping out the faulty camera module.

1. 1

   Power Off and Safety Prep

   • Turn off your iPhone 11 completely before starting the repair.
   • Ensure the battery is discharged below 25% to minimize the risk of a dangerous thermal event if the battery is accidentally punctured during the process.
2. 2

   Remove the Bottom Pentalobe Screws

   • Use a P2 Pentalobe screwdriver to remove the two 6.7 mm-long screws located on either side of the Lightning charging port.
   • Keep these screws separate from the internal screws, as they have a unique thread pattern.
3. 3

   Soften the Display Adhesive

   • Apply heat to the bottom edge of the iPhone using a heat gun or hair dryer on a low setting for about 1 to 2 minutes.
   • This softens the strong waterproof adhesive securing the screen to the frame.
4. 4

   Create a Gap and Slice the Adhesive

   • Place a suction cup on the lower half of the display, just above the bottom edge.
   • Pull up with steady, firm pressure to create a small gap between the screen glass and the frame, then insert a plastic opening pick.
   • Slide the pick carefully around the bottom and up the sides to slice through the adhesive.
5. 5

   Open the iPhone Like a Book

   • Gently swing the display open from the left side toward the right, using the right edge as a hinge.
   • Do not attempt to separate the screen completely yet, as delicate ribbon cables still connect it to the logic board.
   • Prop the screen up at a 90-degree angle against a sturdy object to avoid straining the cables.
6. 6

   Remove the Connector Bracket

   • Use a Tri-point Y000 screwdriver to remove the three 1.1 mm screws securing the metal bracket over the battery and display connectors.
   • Use tweezers to lift the bracket out of the phone and set it aside.
7. 7

   Disconnect the Battery First

   • Use the flat edge of a nylon spudger to pry the battery connector straight up out of its socket.
   • Crucial safety step: Always disconnect the battery before touching any other internal connectors to prevent short circuits or blown backlight fuses.
8. 8

   Disconnect the Display and Sensor Cables

   • Use your spudger to disconnect the two display flex cables and the front sensor assembly cable.
   • Once all three cables are disconnected, lift the display assembly away completely and store it in a safe, dust-free place.
9. 9

   Remove the Rear Camera Bracket

   • Locate the dual rear camera module in the top-right corner of the phone's chassis.
   • Use your Tri-point Y000 screwdriver to remove the two screws securing the metal cover plate over the camera module, then lift the bracket out.
10. 10

    Disconnect and Extract the Camera Module

    • Use a plastic spudger to gently pry up and disconnect the two camera flex cable connectors from the logic board.
    • Carefully slide the spudger under the camera module to lift it out of its recessed housing.
11. 11

    Install the New Camera and Reassemble

    • Place the new dual camera module into the housing, ensuring it sits perfectly flush.
    • Press down gently on the two flex cable connectors until they click into place, reinstall the metal camera bracket, and secure it with its two Y000 screws.
    • Reconnect the display and sensor cables, plug the battery back in, and test the phone before applying new adhesive and closing the display.

Device