Samsung Galaxy S25 Rear Camera Replacement
If your Samsung Galaxy S25 is taking blurry photos, failing to focus, or showing a blank screen when you open the camera app, it might be time for a camera replacement. This repair is also necessary if the internal camera sensors are damaged from a heavy drop or liquid exposure. Expect to work with delicate ribbon cables and strong adhesive during this process. Take your time and proceed carefully to avoid damaging the fragile glass components.
Required Tools
- Heat gun or iOpener
- Suction cup handle
- Plastic opening picks
- Nylon spudger
- Phillips #00 screwdriver
- Precision tweezers
- Replacement waterproof adhesive
- High concentration isopropyl alcohol
Step by step
- 1
Step 1: Heat the back glass
Apply heat to the edges of the back glass using a heat gun or iOpener to soften the factory adhesive.
Keep the heat moving constantly to avoid damaging the internal components or melting the plastic frame.
- 2
Step 2: Create an opening gap
Apply a suction cup to the lower portion of the back glass and pull up gently.
Insert a plastic opening pick into the small gap you create between the glass and the metal frame.
- 3
Step 3: Slice through the adhesive
Slide the opening pick around the entire perimeter of the phone to cut through the waterproof adhesive.
Leave picks in the corners to prevent the adhesive from resealing while you work.
- 4
Step 4: Remove the back glass
Once all the adhesive is cut, carefully lift the back glass away from the phone.
Set it aside in a safe place to avoid cracking it.
- 5
Step 5: Unscrew the motherboard shield
Use a Phillips #00 screwdriver to remove the screws securing the motherboard shield and wireless charging coil.
Keep your screws organized on a magnetic mat so you know exactly where they go during reassembly.
- 6
Step 6: Disconnect the battery
Use a plastic spudger to gently pry up the battery connector from the motherboard.
Disconnecting the battery immediately prevents any accidental short circuits while you work on the rest of the device.
- 7
Step 7: Remove the wireless charging coil
Carefully peel back and remove the wireless charging coil and motherboard shield assembly.
Be gentle to avoid tearing the delicate charging coil material.
- 8
Step 8: Disconnect the camera cables
Locate the press connectors for the rear camera module on the motherboard.
Use the flat end of your plastic spudger to pry them straight up from their sockets.
- 9
Step 9: Extract the camera module
Carefully lift the rear camera module out of its housing in the frame.
If it feels stuck, check for any hidden screws or use a small amount of isopropyl alcohol to loosen any underlying adhesive.
- 10
Step 10: Install the new camera
Place your replacement camera module into the housing and gently press the connectors down onto the motherboard until they snap into place.
Reconnect the battery, reinstall the wireless charging coil, and seal the phone with fresh adhesive before turning it on.
Would you rather leave the repair to the experts?
Disclaimer: repairs are done at your own risk. Devices contain batteries and live components; improper handling can cause injury or fire. For a safe, warrantied repair, contact us.
Frequently asked questions
You will lose the factory water resistance seal when you open the phone. You must apply new, high-quality waterproof adhesive during reassembly to restore some level of protection.
In most cases, the Samsung Galaxy S25 will recognize the new camera hardware automatically without requiring special software calibration. Just make sure the connectors are seated properly.
Check the camera lenses for smudges or protective plastic films that might have been left on during installation. If the lens is clean, reseat the camera ribbon cables to ensure a solid connection.
The rear camera assembly is typically replaced as a single module containing all the sensors. However, if only the exterior glass cover is broken, you can replace just the glass without opening the entire phone.